EN
PATTERN

Battery & Inverter Compatibility

A battery can have the right voltage and still be the wrong partner for an inverter. Check the operating voltage, continuous current, communication protocol and approved wiring arrangement before confirming a system order.

Quick answer: A 51.2V LiFePO4 battery is a 48V-class storage platform, but that label alone does not establish compatibility. CAN or RS485 ports must use the correct protocol and pinout, and the battery bank must support the inverter’s charging and discharge demand.

Start with these four checks

CheckWhat the buyer needs to confirmWhy it matters
Battery voltageBattery charge limits and cut-off settings fall within the inverter’s permitted DC range.A matching nominal voltage is only the first check.
Continuous currentBattery BMS, cells, cables and protection support the intended charge and discharge current.Stored energy in kWh does not determine available power in kW.
CommunicationExact inverter model, firmware, selected battery protocol, cable pinout and battery firmware.A CAN socket or RS485 connector does not guarantee that two devices understand each other.
Expansion and wiringModel-specific parallel limits, battery addressing, current sharing, protection and earthing instructions.A parallel battery bank needs a verified system configuration.

PATTERN models: a starting point for engineering review

The following are published product specifications, not an approval matrix. Each battery–inverter combination still requires review for the exact models and firmware supplied.

ProductPublished battery-side informationSelection note
17.92kWh battery — PD-17.5KW51.2V, 350Ah; maximum charging current 100A; continuous discharge current 160A.PD-17.5KW is the model identifier. It does not mean 17.5kW output.
10kW GES48100M220-500P51.2V nominal battery platform; 40–60V battery range; maximum charge/discharge current 220A.120/240V split-phase AC output. Review the battery bank’s current capability for the intended load.
12kW GES48120M250-500XP51.2V nominal battery platform; maximum charge current 250A and discharge current 270A.120/240V split-phase AC output. Confirm BMS communication and model-specific parallel settings.

Why a large battery may not support full inverter output

Consider a 10kW AC load supplied from a 51.2V battery. At an assumed 93% conversion efficiency, estimated battery current is:

10,000W ÷ (51.2V × 0.93) ≈ 210A.

A single battery limited to 160A continuous discharge would not support that 10kW load on battery power alone. At the same assumed voltage and efficiency, 160A represents about 7.62kW before any additional operating restrictions. Current demand rises as battery voltage falls.

This is a screening calculation, not a guaranteed output rating or installation design. Battery condition, inverter operating limits, temperature and cable losses also matter. Use the actual operating voltage and final documentation for the supplied equipment.

Already using Deye, Sunsynk, Growatt, Victron or Voltronic?

Send the full inverter model and firmware version. These brands cover multiple voltage platforms and protocols; a brand name is not enough to approve a battery.

For a distributor order, request written confirmation covering the exact battery model, BMS firmware, inverter firmware, communication cable and settings. If no documented pairing is available, arrange sample testing before committing to a complete system.

Compatibility status: this page provides a selection and verification process. It does not claim that all PATTERN batteries work with every model from any listed brand, or that a particular combination holds system-level certification.

Send these details for a compatibility review

  • Inverter brand, full model number and firmware version.
  • Battery model, quantity and BMS firmware, if already selected.
  • Battery operating voltage and continuous charge/discharge limits.
  • Required backup loads, motor starting requirements and backup duration.
  • Country, grid/AC configuration and intended operating mode.
  • Initial order quantity and OEM/private-label requirements.

Request a Battery–Inverter Compatibility Review

Downloads and related guides

WhatsApp Us Call Get Quote Factory direct · Reply within 4 working hours · English support